Thinkcar Pro Flashing Scheme

[Skorpi]

You know the procedure for Mucar 200? The same here!

pls if any one know procedure can share with us

 

[ahmed11]

You know the procedure for Mucar 200? The same here!

dear i want download.bin file for frimwork update pls

 

[Skorpi]

dear i want download.bin file for frimwork update pls

The same as for Mucar.

 

[ahmed11]

The same as for Mucar.

dear i don know where solder point and i want file downlod bin you found in download bath

 

[Skorpi]

dear I can't help you if you can't read

 

[mhrm1]

The same as for Mucar.

Посмотреть вложение 3686
red is 12V and black GND

Посмотреть вложение 3687

my friend, your described scheme really doesn't work, it has already been tested and revised countless times, reveal the secret...

 

[Skorpi]

my friend, your described scheme really doesn't work, it has already been tested and revised countless times, reveal the secret...

 

[Skorpi]

I don't see any secrets there, there is nothing different from Mucar!

 

[JoeinCA]

I already flashed once but said need microcode to work, so want to try with different one.

 

[Mukar200]

I already flashed once

Какой контроллер установлен в том что прошивали и чем прошивали , каким дампом и откуда брали ?

 

[mhrm1]

Good, send step by step with pictures...

 

[mhrm1]

look at my circuit board, it seems to be slightly different from yours, there is a resistor near the reset point, maybe the soldering points are different...

 

[Skorpi]

it's an capacitor but i think it should work.

 

[mhrm1]

it's an capacitor but i think it should work.

unfortunately it doesn't work, when I apply the reset the PCB turns off and when I remove the reset it turns on again and the boot doesn't happen generating the USB communication error

 

[Skorpi]

Do you have instructions for Mucar? Can you post it here?

 

[Mukar200]

instructions for Mucar?

Mucar, Thinkdiag mini, Ediag mini, Thinkcar pro, Thinksafe – Google Drive

drive.google.com

 

[JoeinCA]

What controller is installed in what was flashed and what was it flashed with, what dump and where did you get it from?

No idea on controler, it is a MUCAR 200
Used ST LINK V2
I had a ** dump initially, and it wasn't working on DIAGZONE,
right after i found a *** dump and got it working as PRO device .
I pulled them online of multiple sites selling the software and hardware.

 

[Mukar200]

Used ST LINK V2

original or clone ? on clone pinout is different , you know .

 

[mhrm1]

it's an capacitor but i think it should work.

Do you have instructions for Mucar? Can you post it here?

Yes, I do, and I know how to do it, minutes before I had just made a bt200, if you could photograph in detail its connections to the PCB it would help a lot in my review of connections and soldering points.

 

[Skorpi]

no Problem, here: